Hurco winmax - Repeat Start and Repeat End Block Sample

2 - 204 Conversational Part Programming v546CO WinMax Lathe Conversational Part Programming
Repeat Start and Repeat End Block Sample
The following Program Review screen contains Repeat Start and Repeat End data blocks
(#3 and #5, respectively) programmed around a Drill data block (#4).
Figure 2–165. Program Review Screen with Repeat Start and Repeat Stop Blocks
Here is the Repeat Start data block, Block 3, with the REPEAT COUNT field set at 2. This
means the Drill data block that follows this Repeat Start block will drill the hole twice,
exactly the same each time.
Figure 2–166. Repeat Start screen