Hurco winmax - Page 21

WinMax Lathe Conversational Part Programming v546CO Overview 1-9
These Standard Console keys perform these functions with the Program Review screen:
•The Insert console key functions the same as the INSERT BLOCK BEFORE F7
softkey:
1. Highlight a data block in the Program Review screen.
2. Press the Insert key. The New Block softkeys appear.
3. Select the softkey for the new data block. The new block appears above
the highlighted block.
•The Delete console key functions the same as the DELETE BLOCK F2 softkey:
1. Highlight the data block to be deleted in the Program Review screen.
2. Press the Delete key. A pop-up message appears asking if you are sure
you want to delete the block.
3. Select OK to delete the block or Cancel to cancel the deletion.
•The Home console key jumps to the first data block listed in the Program
Review screen.
•The End console key jumps to the End of Program data block listed in the
Program Review screen.
•The Page Up console key jumps to the first data block visible on the screen.
•The Page Down console key jumps to the last data block visible on the
screen.
You can cut, copy, and move data blocks to another location in a part program or even
another program.
When the entire part program contains more data blocks than can be
displayed on one screen, use the Page Down and Page Up console
keys or the scroll bar located on the right-hand side of the screen to
scroll through the listed data blocks.
To select multiple blocks, select the block listed first and move the
stylus down to the last block without lifting the stylus.
With the optional AT-keyboard, you can use Ctrl + select (using the
stylus) to select non-consecutive data blocks.
The Cut and Copy softkeys function with data blocks but not with
elements.