Hurco winmax - Page 32

WinMax Lathe Conversational Part Programming v546CO Conversational Part Programming 2-9
• FIRST X THEN Y THEN Z F4—from the current position before the
Position block, the turret moves the X axis first to the X position, then the
Y axis moves to the Y position, then the Z axis to the Z position. This field
is available for TMX MY and TMX MYS Series machines.
• FIRST Z THEN Y THEN X F5—from the current position before the
Position block, the turret moves the Z axis first to the Z position, then the
Y axis moves to the Y position, then the X axis to the X position. This field
is available for TMX MY and TMX MYS Series machines.
• FIRST Y THEN X THEN Z F6—from the current position before the
Position block, the Y axis moves first to the Y position, then the turret
moves the X axis to the X position, then the Z axis to the Z position. This
field is available for TMX MY, and TMX MYS Series machines.
• FIRST Y THEN Z THEN X F7—from the current position before the
Position block, the Y axis moves first to the Y position, then the turret
moves the Z axis to the Z position, then the X axis to the X position. This
field is available for TMX MY and TMX MYS Series machines.
After the tool change is complete, the Position move is run using the other parameters
listed.