3 Setup
301-7146 English Rev B 11/02/2011 Operator’s Manual NA 45
Chapter 3 – Setup
This section describes the steps necessary to setup and to customize the
system.
The
iChemVELOCITY must be initially turned on in the following order to
achieve correct communication between the instrument and the
computer:
1. At initial start-up or if the instrument has been turned off completely,
start the iChemVELOCITY by pressing the power switch on the back
of the instrument. During routine use, this button will remain on.
2. Press the ON button located on the front of the instrument to apply
power to the system.
3. When the Instrument Screen is displayed on the monitor, the status
light will turn green.
4. If the optional Load/Unload Stations are attached, they should be
empty during power up.
5. If the optional Load/Unload Stations are attached, turn on the power
by pressing the power switch at the rear of the Load/Unload Station.
To Next Page
Loading...