3 Setup
301-7146 English Rev B 11/02/2011 Operator’s Manual NA 60
8. From the System Configuration screen, make sure the proper settings
are displayed.
9. Click the Save as Backup button.
10. Click the OK button. The system will prompt to restart the software.
From the Instrument screen, click the Maintenance button, and then
click the Restart button.
Validating the Changes
1. Click OK to validate the entries and close the screen.
2. If any change is made to the System Configuration settings, the
system must be restarted for the changes to take effect. After
rebooting, the Instrument screen will be displayed.
To Next Page
Loading...