3 Setup
301-7146 English Rev B 11/02/2011 Operator’s Manual NA 61
LIS Interface Settings
The LIS Interface screen is used to enable LIS communication and
configure the LIS communication settings. It is used also to enter the
patient demographics settings.
The following options are only available if an iQ Series module is
connected to the chemistry system:
• Obtain Chemistry Information from LIS
• Suppress Usage of Generated Chemistry Results when Obtaining
Specimen Information from LIS
• Specimen Information to LIS
• Send Chemistry Information before Querying LIS
Enable LIS
Check this box to enable communication with the LIS.
To Next Page