EasyManuals Logo

Juniper EX2200 Hardware Guide

Juniper EX2200
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
Regex or wildcards are not supported for interface-type prefixes. For example, prefixes
ge, fe, and xe must be mentioned explicitly.
An interface-range definition can contain both member and member-range statements
within it. There is no maximum limit on the number of member or member-range
statements within an interface-range. However, at least one member or member-range
statement must exist within an interface-range definition.
Example: Interface
Range Common
Configuration
Configuration common to an interface range can be added as a part of the interface-range
definition, as follows:
[edit]
interfaces {
+ interface-range foo {
+ member-range ge-1/0/0 to ge-4/0/40;
+ member ge-0/1/1;
+ member ge-5/[1-10]/*;
/*Common configuration is added as part of interface-range definition*/
mtu 256;
hold-time up 10;
ether-options {
flow-control;
speed {
100m;
}
802.3ad primary;
}
}
}
An interface-range definition having just member or member-range statements and no
common configurations statements is valid.
These defined interface ranges can be used in other configuration hierarchies, in places
where an interface node exists.
Example:
Interface-Range foo
protocols {
dot1x {
authenticator {
Used Under the
Protocols Hierarchy
interface foo{
retries 1;
}
}
}
}
foo should be an interface-range defined at the [interfaces] hierarchy level. In the above
example, the interface node can accept both individual interfaces and interface ranges.
TIP: To view an interface range in expanded configuration, use the (show |
display inheritance) command. For more information, see the CLI User Guide.
Copyright © 2015, Juniper Networks, Inc.68
Network Interfaces for EX4300 Switches

Table of Contents

Other manuals for Juniper EX2200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper EX2200 and is the answer not in the manual?

Juniper EX2200 Specifications

General IconGeneral
Throughput77 Mpps
MAC address table8000 entries
Jumbo frames supportYes
Number of VLANs1024
Networking standards-
Switch typeManaged
SFP module slots quantity4
Installed SFP modules quantity0
Basic switching RJ-45 Ethernet ports quantity48
StackableNo
Product colorBlack
Power consumption (typical)100 W
Operating altitude0 - 3048 m
Non-operating altitude0 - 4877 m
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Depth254 mm
Width441 mm
Height43 mm
Weight3600 g

Related product manuals