SEQ P8: Routing/IFX (Insert Effect) 8–9: FX Control T01–08, 8–10: FX Control T09–16
151
8–9(10)d: Routing2
Bus (IFX/Output) Select [L/R, IFX1...5, Off]
This specifies the output bus for the
oscillator(s). This is the same parameter as in the 8–1: IFX–
Routing 1 T01–08 and T09–16 pages.
For more information, please see “Bus (IFX/Output) Select”
on page 148.
FX Control Bus [Off, 1, 2]
Sends the output of the track to an FX Control bus (two‐
channel mono FX Ctrl 1 or 2).
Use the FX Control buses when you want a separate sound
to control the audio input of an effect. You can use two FX
Control buses (each is a two‐channel mono bus) to control
effects in various ways.
For more information, please see “FX Control Buses” on
page 238.
V
8–9(10): Menu Command
• 0: Memory Status see p. 163
• 1: Exclusive Solo see p. 64
• 2: Copy Insert Effect see p. 66
• 3: Swap Insert Effect see p. 67
• 4: DrumKit IFX Patch see p. 104
• 5: FF/REW Speed see p. 164
• 6: Set Location (Set Location for Locate Key) see p. 164
• 7: Put Effect Setting to Track see p. 184
For more information, please see “Sequencer: Menu
Command” on page 163.
To Next Page
Loading...
