Kyocera FS-C8600DN - Maintenance Mode Workflow

2MN/2N1
1-3-146
U952 Maintenance mode workflow
Description
The maintenance modes configured in the machine or a USB flash device as a workflow must be
executed in succession.
Purpose
This allows maintenance mode to be preset as a template.
Setting
1. Press the OK key.
2. Select the item.
Method: [Exec]
1. Select [Execute].
2. Select the workflow.
3. Press the OK key.
Executes maintenance modes defined in a workflow in succession.
Method: [Entry]
1. Select [Entry].
2. Select the area to store workflow.
3. Press the numeric keys to assign a maintenance Nbr. into a workflow.
4. Press the OK key. The setting is set.
5. Press the OK key.
Executes maintenance modes defined in a workflow in succession.
Item No. Description
Display Description
Continue Restarting an abandoned workflow
Exec(USB) Executes a workflow housed in a USB flash device
Exec Executes a workflow stored in the machine
Entry(USB) Exports a workflow housed in a USB flash device to the machine
Entry Assigns a workflow in the machine manually
Log Displays a list of workflows recently executed
Display Description
Data1 - 6 The area to store workflows in the machine
Display Description
Data1 - 6 The area to store workflows in the machine
Display Description
Flow1 - 14 Assign a maintenance Nbr.