Model 831 Manual Run Control 6-1
CHAPTER
6
Run Control
The Model 831 provides a number of run modes to
control the time duration of a measurement. The most
simple are Manual Stop, Timed Stop and Stop when
Stable. More advanced are the Continuous, Single Block
Time and Daily Timer modes. When combined with the
Measurement History feature, these modes produce a
sequence of measurements made and stored at regular
time intervals. In this chapter the setup of run modes
without the Measurement History are discussed in detail.
The description of the setup and use of run modes with
Measurement History enabled is continued in Chapter
12 "Measurement History" on page 12-1.
Run Control Setup
The Run Control is setup from the Control tab of the
Measurement Setting Screen, as shown in Figure 6-1.
FIGURE 6-1 Control Tab
The Control tab is used to set the Run Mode for the
measurement to be performed.
To Next Page
Loading...
