3-12 Navigating and Selecting Model 831 Manual
Changing Views
In the Data Views, the labels of the Left and Right Softkeys
are left and right arrow symbols, respectively. These indicate
that the Left and Right Softkeys are used to scroll the
selection of the tab being displayed in the corresponding
direction. One press of the Right Softkey will bring up the
Session Log View, and a second press will bring up the
Current tab. Then, sequential presses of the Left Softkey will
bring up the Session Log View, then the Overall tab.
Navigating and Selecting
To navigate between tabs on the display, press the right or
left Softkeys. To navigate within tabs, use the 4 and 6 keys
for moving horizontally on screens. This includes moving
the highlight from one property to the next.
The 8 and 2 keys are used for moving vertically on
screens. This includes moving the highlight from one
property to the next and to move to previous or subsequent
tabs.
These keys are also used for character entry by navigating
through lists of characters in text boxes.
The
5 (ENTER) key is typically used for completing
selections completing actions, or accepting values.
Basic Run Functions
The basic measurement run functions are as follows:
• Running
•Pausing
• Stopping
•Storing
The
9 (RUN/PAUSE) key initiates a run. If a
measurement is running, this key pauses the run. It does not
end the run; to end the measurement run, press the
7
(STOP/STORE) key. Pressing the 9 key when the unit is
PAUSED continues the run. This key is only active on a
Data View screen.
To Next Page
Loading...
