Model 831 Manual Manual and Stop When Stable Modes 12-5
Manual and Stop When Stable Modes
For these run modes, the
Measurement History does not
automate the measurement and
storage of data as it does for the
Continuous, Single Block Timer and
Daily Timer modes. However, it does
simplify the number of key presses
required when making multiple
measurements.
For these run modes, at the conclusion of a measurement,
the data must be manually saved. Checking the “Enable
Measurement History” checkbox does not add additional
parameter fields to the display as it does with Continuous,
Single Block Timer and Daily Timer modes.
With the Measurement History enabled, sequentially
pressing the 7 and 9 keys will store the measurement
and initiate another measurement, eliminating the need to
perform a separate data store operation.
Display of Measurement History Data
Note that the ANY LEVEL display of
sound levels measured using all
combinations of frequency weighting
and time averaging can also be
accessed from both the Current and
the Measurement tabs. See "Any
Level Display" on page 5-41.
Measurement History data is displayed on the Current tab
and the Measurement tab. These tabs are located to the
right of the Session Log tab.
To Next Page
Loading...
