Model 831 Manual Industrial Hygiene 9-1
CHAPTER
9
Industrial Hygiene
This chapter describes the measurement features
associated with the Industrial Hygiene optional firmware
831-IH.
Measurement Setup
The Industrial Hygiene measurement features are setup from
the Settings Screen, in the same manner as the basic
measurement parameters are setup as described in Chapter 4
“Basic Measurement Setup” on page 4-1.
When this firmware is loaded, the Dosimeter 1 and
Dosimeter 2 tabs appear, which are provided to permit the
evaluation of two independent noise dose data sets. Other
than being on separate pages, they are identical. The default
values for Dosimeter 1 tab parameters are shown in
FIGURE 9-1.
FIGURE 9-1 Dosimeter 1
To Next Page
Loading...
