9-2 Measurement Setup Model 831 Manual
Predefined Setups
In most cases, measurements of this type are setup to
conform to a specific standard. The Model 831 permits the
user to create such a setup in a single step by simply
selecting the applicable standard. The standards addressed
by the Model 831 and the corresponding parameters are as
shown in Table 9-1 'Predefined Noise Dosimeter Setups'.
The Name field will already be
highlighted when the Dosimeter 1 or
Dosimeter 2 sections are opened. If
this has been changed, use the 8 key
to move the highlight back to the
Name field.
The names of the predefined setups can be accessed from the
Name field at the top of the display. Press the
5 (ENTER)
key to drop down a list of predefined setups by name as
shown in FIGURE 9-2.
FIGURE 9-2 Predefined Dose Setups
Highlight the name of the desired setup and press
5 to
make the selection. The name of this setup will now appear
in the Name field.
Standard
Exchange
Rate
Threshold Criterion
Level Hours
OSHA-1 5 90 90 8
OSHA-2 5 80 90 8
ACGIH 3 80 85 8
NIOSH 3 80 85 8
IEC 3 Not Enabled 85 8
Table 9-1 Predefined Noise Dosimeter Setups
To Next Page
Loading...
