Larson Davis 831 - Weather Measurement Using 831-INT

19-2 Weather Measurement Using 831-INT Model 831 Manual
• 4-port Powered USB Hub
• 2 Digital I/O lines: 1 in, 1 out
Weather Measurement Using 831-INT
Note that the optional firmware 831-WTHR must be enabled
in order to measure weather parameters with the Model 831.
Larson Davis Sensors
The following devices are available from Larson Davis for
the measurement of weather data:
The SEN028, SEN029, and SEN030
products are no longer supported.
• SEN028 Wind Monitor: Wind Speed and Direction
• SEN029 Anemometer (Low Cost): Wind Speed and
Direction
• SEN030 Sensor: Temperature and Humidity
These sensors connect to the Model 831 via the 831-INT.
Setup
The parameters controlling the measurement of weather data
are setup from the Weather tab shown in.FIGURE 19-2.
FIGURE 19-2 Weather-INT Setup