Model 831 Manual Status Tab 20-19
States
There are many possible states that each device can be in.
This section lists the most common ones.
Connect Wait
The wireless modem has successfully registered and
communicated with an application. This state will persist for
2 minutes before moving on to the next state.
Connected
The device is connected to and is being remotely controlled
by an application (G3-utility)
Device Found
A device has been found on one of the communication
channels and is being identified.
Disconnected
The device has been disconnected from the remote
application.
Initializing
The connected device is currently being initialized.
Internet
The wireless modem is connected to an IP address.
Sleep
It is only possible to have one device communicating at a
time. If you attempt to enable or use more than one device
the currently active device will enter a sleep state.
To Next Page
Loading...
