3-26 824 Reference Manual 11/8/00
Run Date
- Specifies the starting date to take measurements.
Stop Date
- Specifies the date to end the measurement and
disable the timer mode.
Run Time 1
/
Stop Time 1
- These settings allow you to
specify the beginning and ending times of a measurement.
NOTE: If you have selected the
Block,
1/Day
or
2/Day
mode, the timer will
automatically turn the instrument on one
minute prior to the run time.
Run Time 2 / Stop Time 2
- These settings are used to spec-
ify a second measurement’s beginning and ending time in
the 2/day timer mode.
To Next Page
Loading...
