Lenovo ThinkServer RD650 - Page 158

LSI Corporation
- 158 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Chapter 6: StorCLI
StorCLI Command Syntax
NOTE JSON format output is not supported in the EFI operating system. The
EFI platform ignores the J when it is added at the end of the command
syntax.
NOTE Background operations are blocked in the EFI and HII environments
and these operations are resumed in the operating system
environments.
The StorCLI syntax uses the following general format:
<[object identifier]> <verb> <[adverb | attributes | properties] > <[key=value]>
The StorCLI tool supports the object identifiers listed in the following table.
Table 35 Object Identifiers in the StorCli Command Syntax
NOTE If enclosures are not used to connect physical drives to the controller,
you do not specify the enclosure ID in the command.
The StorCLI tool supports the following verbs.
Object Identifier Description
No object identifier specified If there is no object identifier, the command is a system command.
/cx This object identifier is for controller x.
/cx/vx This object identifier is for a virtual drive x on controller x.
/cx/vall This object identifier is for all virtual drives on controller x.
/cx/ex This object identifier is for an enclosure x on controller x.
/cx/eall This object identifier is for all enclosures on controller x.
/cx/fx This object identifier is for a foreign configuration x on controller x.
/cx/fall This object identifier is for all foreign configurations on controller x.
/cx/ex/sx This object identifier is for the drive is slot x on enclosure x on controller x.
/cx/sx This object identifier represents the drives that are directly attached to controller x.
/cx/ex/sall This object identifier is for all the drives on enclosure x on controller x.
/cx/dx This object identifier is for the drive group x on enclosure x on controller x.
/cx/dall This object identifier is for the all drive groups on enclosure x on controller x.
/cx/px This object identifier is for a PHY operation x on controller x
/cx/pall This object identifier is for all PHY operations on controller x
/cx
/bbu This object identifier is for a BBU x on controller x
/cx/cv This object identifier is for a cache vault x on controller x