LSI Corporation
- 77 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Chapter 4: Ctrl-R Utility
Viewing and Changing Device Properties
Figure 50 Convert Unconfigured Good to JBOD
3. Select the Unconfigured Good drives which you want configured as JBODs.
To select or deselect all the Unconfigured Good drives at one go, select the top most square brackets in the
Unconfig good drives box.
4. Press OK.
The selected Unconfigured Good drives are converted to JBOD drives.
Perform the following steps to convert a particular Unconfigured Good drive to a JBOD drive:
1. In the Drive Management screen, navigate to a Unconfigured Good drive, and press the F2 key.
2. Navigate to Make JBOD, and press Enter.
3. Press OK in the message confirmation box to continue.
4.13 Viewing and Changing Device Properties
This section explains how you can use the Ctrl-R Utility to view and change the properties for controllers, virtual
drives, drive groups, physical drives, and BBUs.
4.13.1 Viewing Controller Properties
The Ctrl-R Utility shows information for one LSI SAS controller at a time. If your system has multiple LSI SAS controllers,
you can view information for a different controller by pressing the F12 key and selecting a controller from the list.
Navigate to the Properties menu to view the properties of the active controller.
To Next Page
Loading...
