Lenovo ThinkServer RD650 - Editing Alert Delivery Methods

LSI Corporation
- 295 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Chapter 10: Monitoring Controllers and Their Attached Devices
Editing Alert Delivery Methods
 Load all of the values from a previously saved backup into the dialog to edit or save these values as the current
alert notification configuration.
NOTE When you load a saved backup file, all unsaved changes made in the
current session will be lost.
You can select the Email tab to perform the following actions:
 Add new email addresses for recipients of alert notifications.
 Send test messages to the recipient email addresses.
 Remove email addresses of recipients of alert notifications.
 Save an .xml backup file of the entire alert configuration.
 Load all of the values from a previously saved backup into the dialog to edit or save these values as the current
alert notification configuration.
NOTE When you load a saved backup file, all unsaved changes made in the
current session will be lost.
10.3 Editing Alert Delivery Methods
You can edit the default alert delivery methods, such as pop-up, email, system log, or the Vivaldi Log/MegaRAID
Storage Manager log to a different severity level (Information, Warning, Critical and Fatal).
Perform the following steps to edit the alert delivery methods:
1. On the Configure Alerts window, click the Alerts Setting tab.
2. Under the Alerts Delivery Methods heading, select one of the severity levels.
3. Click Edit.
The Edit dialog appears.
Figure 182 Edit Dialog
4. Select the desired alert delivery methods for alert notifications at the event severity level.
5. Click OK to set the delivery methods used for the severity level that you selected.