LSI Corporation
- 400 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Appendix E: CLI Error Messages
Appendix E: CLI Error Messages
This appendix lists the MegaRAID Storage Manager software error messages.
The Storage Command Line Tool (StorCLI) and the MegaCLI Configuration Utility are command line interface
applications you can use to manage MegaRAID SAS RAID controllers.
E.1 Error Messages and Descriptions
Each message that appears in the event log has an error level that indicates the severity of the event, as shown in the
following table.
Table 84 Error Messages and Descriptions
Number Event Text
0x00 Command completed successfully
0x01 Invalid command
0x02 DCMD opcode is invalid
0x03 Input parameters are invalid
0x04 Invalid sequence number
0x05 Abort isn't possible for the requested command
0x06 Application 'host' code not found
0x07 Application already in use - try later
0x08 Application not initialized
0x09 Given array index is invalid
0x0a Unable to add missing drive to array, as row has no empty slots
0x0b Some of the CFG resources conflict with each other or the current config
0x0c Invalid device ID / select-timeout
0x0d Drive is too small for requested operation
0x0e Flash memory allocation failed
0x0f Flash download already in progress
0x10 Flash operation failed
0x11 Flash image was bad
0x12 Downloaded flash image is incomplete
0x13 Flash OPEN was not done
0x14 Flash sequence is not active
0x15 Flush command failed
0x16 Specified application doesn't have host-resident code
0x17 LD operation not possible - CC is in progress
0x18 LD initialization in progress
0x19 LBA is out of range
0x1a Maximum LDs are already configured
0x1b LD is not OPTIMAL
To Next Page
Loading...
