LSI Corporation
- 211 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Chapter 7: MegaRAID Storage Manager Overview and Installation
Installing MegaRAID Storage Manager
NOTE LSI MegaRAID CacheCade Pro 2.0 software is not applicable in SPARC.
7.3.5 Uninstalling MegaRAID Storage Manager Software on Solaris 10 (U5, U6, U7, U8, U9, and
U10), 11 (x86 and x64), and SPARC
Follow these steps to uninstall the MegaRAID Storage Manager software on a system running Solaris operating
systems:
1. Execute the Uninstaller.sh file located in /opt/MegaRaidStorageManager directory.
2. When prompted by the uninstallation scripts, select Y to complete the installation.
To shut down the MegaRAID Storage Manager Framework service, run the svcadm disable -t MSMFramework
command.
To start the Framework service, run the svcadm enable MSMFramework command.
When the service is in maintenance state, run the svcadm clear MSMFramework command.
To check the status of the MegaRAID Storage Manager services, run the svcs-a|grep -i msm command.
7.3.6 Prerequisites for Installing MegaRAID Storage Manager on the RHEL6.X x64 Operating
System
Before installing the MegaRAID Storage Manager software on RHEL 6.X x64 system, install the following RPMs.
Without these RPMs the MegaRAID Storage Manager software might not install properly or might not work as
expected.
libstdc++-4.4.4-13.el6.i686.rpm
compat-libstdc++-33-3.2.3-69.i686.rpm
libXau-1.0.5-1.el6.i686.rpm
libxcb-1.5-1.el6.i686.rpm
libX11-1.3-2.el6.i686.rpm
libXext-1.1-3.el6.i686.rpm
libXi-1.3-3.el6.i686.rpm
libXtst-1.0.99.2-3.el6.i686.rpm
The RHEL6.X x64 complete operating system installation is required for the MegaRAID Storage Manager software to
work. The above mentioned RPMs come as part of RHEL6.X x64 Operating System DVD. These RPMs might need
additional dependent RPMs as well, and you must install all the dependent RPMs on the target system.
NOTE The RPMs versions mentioned above may get changed in the future
RHEL6.x releases. Install the corresponding RPMs from the operating
system installation media.
NOTE The MegaRAID Storage Manager software now provides an additional
binary to run it in a native 64-bit Linux environment.
7.3.7 Installing MegaRAID Storage Manager Software on RHEL or SLES/SUSE Linux
Follow these steps if you need to install the MegaRAID Storage Manager software on a system running Red Hat Linux
3.0, 4.0,5.0, 6.0 or SUSE Linux/SLES 9, 10, and 11: