Lenovo ThinkServer RD650 - Controller Show Commands

LSI Corporation
- 164 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Chapter 6: StorCLI
Working with the Storage Command Line Tool
6.6.2.2 Controller Show Commands
The Storage Command Line Tool supports the following show commands:
storcli /cx show
storcli /cx show all
storcli /cx show freespace
dimmerswitch|ds See Dimmer Switch Commands. See Dimmer Switch Commands.
foreignautoimport on|off Imports foreign configuration automatically, at
boot.
jbod on|off Enables/disables JBOD mode; by default, drives
become system drives.Not supported by all
controllers.
loadbalancemode on|off Enables/disables automatic load balancing
between SAS phys or ports in a wide port
configuration.
maintainpdfailhistory on|off Maintains the physical drive fail history.
migraterate 0 to 100 Sets data migration rate in percentage.
patrolread|pr See Patrol Read. See Patrol Read.
perfmode 0: Tuned to provide best IOPS, currently
applicable to non-FastPath
1: Tuned to provide least latency, currently
applicable to non-FastPath
Performance tuning setting for the controller.
pi on|off Enables/disables data protection on the
controller.
pi import on|off Enables/disables import data protection drives
on the controller.
prcorrectunconfiguredareas on|off Correct media errors during PR by writing 0s to
unconfigured areas of the disk.
prrate 0 to 100 Sets patrol read rate of the virtual drives in
percentage.
rebuildrate 0 to 100 Sets rebuild rate of the drive in percentage.
reconrate 0 to 100 Sets reconstruction rate for a drive in percentage.
restorehotspare on|off Becomes a hot spare on insertion of a failed
drive.
smartpollinterval 0 to 65535 Set time for polling of SMART errors in seconds.
spinupdrivecount 0 to 255 Sets number of drives that are spun up at a time.
spinupdelay 0 to 255 Sets spin-up delay between a group of drives or a
set of drives, in seconds.
stoponerror on|off Stops the MegaRAID BIOS during POST, if any
errors are encountered.
time Valid time in yymmdd hh:mm:ss format
or systemtime
Sets the controller time to your input value or the
system time (local time in 24-hour format).
usefdeonlyencrypt on|off Enables/disables FDE drive-based encryption.
DPM on|off Enables/disables drive performance monitoring
supportssdpatrolread on|off Enables/disables patrol read for SSD drives.
SGPIOforce on|off Force SGPIO status per port only for four drives;
affects HPC controllers.
Property Name Set Command Range Description