LSI Corporation
- 75 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Chapter 4: Ctrl-R Utility
Converting JBOD Drives to Unconfigured Good Drives
Figure 48 Manage Preserved Cache
3. Press Discard Cacheto discard the preserved cache from the virtual drive. A message box appears, asking you to
confirm your choice.
4. Press OK to continue.
4.11 Converting JBOD Drives to Unconfigured Good Drives
You can convert multiple JBODs to Unconfigured Good drives (from the VD Mgmt screen) or you can convert a
particular JBOD drive to an Unconfigured Good drive (from the Drive Management screen).
NOTE The MegaRAID SAS 9240-4i and the MegaRAID SAS 9240-8i controllers
support JBOD.
Perform the following steps to convert multiple JBODs to Unconfigured Good drives:
1. In the VD Mgmt screen, navigate to the controller, and press the F2 key.
2. Navigate to Make Unconfigured Good, and press Enter.
The Convert JBOD to Unconfigured Good dialog appears, which shows all JBODs available in the system.
To Next Page
Loading...
