LSI Corporation
- 86 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Chapter 4: Ctrl-R Utility
Viewing and Changing Device Properties
Figure 57 Manage Power Save – Advanced
2. Perform one of these two actions:
— Specify a start and end time, for the drives to be in active state, in the Start Time and End Time fields,
respectively.
— Select the Do not Schedule Drive Active Time check box to disable the Start Time and End Time fields.
3. Press OK.
4.13.10 Managing Power Save Settings for the Drive Group
You can change the power save settings for a selected drive group.
Perform the following steps to change the power save settings for a drive group:
1. Navigate to a drive group in the VD Mgmt screen, and press the F2 key.
2. Navigate to Manage Power Save Settings and press Enter.
The Manage Power Save Settings dialog appears.
Figure 58 Manage Power Save Settings – Drive Group
3. Select a power save mode from the Select power save mode drop-down list.
A description of the selected mode appears in the dialog.
4. Press OK.
To Next Page
Loading...
