LSI Corporation
- 401 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Appendix E: CLI Error Messages
0x1c LD Rebuild is in progress
0x1d LD is undergoing reconstruction
0x1e LD RAID level is wrong for requested operation
0x1f Too many spares assigned
0x20 Scratch memory not available - try command again later
0x21 Error writing MFC data to SEEPROM
0x22 Required HW is missing (i.e. Alarm or BBU)
0x23 Item not found
0x24 LD drives are not within an enclosure
0x25 PD CLEAR operation is in progress
0x26 Unable to use SATA(SAS) drive to replace SAS(SATA)
0x27 Patrol Read is disabled
0x28 Given row index is invalid
0x2d SCSI command done, but non-GOOD status was received-see mf.hdr.extStatus for SCSI_STATUS
0x2e IO request for MFI_CMD_OP_PD_SCSI failed - see extStatus for DM error
0x2f Matches SCSI RESERVATION_CONFLICT
0x30 One or more of the flush operations failed
0x31 Firmware real-time currently not set
0x32 Command issues while firmware in wrong state (i.e., GET RECON when op not active)
0x33 LD is not OFFLINE - IO not possible
0x34 Peer controller rejected request (possibly due to resource conflict)
0x35 Unable to inform peer of communication changes (retry might be appropriate)
0x36 LD reservation already in progress
0x37 I2C errors were detected
0x38 PCI errors occurred during XOR/DMA operation
0x39 Diagnostics failed - see event log for details
0x3a Unable to process command as boot messages are pending
0x3b Returned in case if foreign configurations are incomplete
0x3d Returned in case if a command is tried on unsupported hardware
0x3e CC scheduling is disabled
0x3f PD CopyBack operation is in progress
0x40 Selected more than one PD per array
0x41 Microcode update operation failed
0x42 Unable to process command as drive security feature is not enabled
0x43 Controller already has a lock key
0x44 Lock key cannot be backed-up
0x45 Lock key backup cannot be verified
0x46 Lock key from backup failed verification
0x47 Rekey operation not allowed, unless controller already has a lock key
Number Event Text