LSI Corporation
- 402 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Appendix E: CLI Error Messages
0x48 Lock key is not valid, cannot authenticate
0x49 Lock key from escrow cannot be used
0x4a Lock key backup (pass-phrase) is required
0x4b Secure LD exist
0x4c LD secure operation is not allowed
0x4d Reprovisioning is not allowed
0x4e Drive security type (FDE or non-FDE) is not appropriate for requested operation
0x4f LD encryption type is not supported
0x50 Cannot mix FDE and non-FDE drives in same array
0x51 Cannot mix secure and unsecured LD in same array
0x52 Secret key not allowed
0x53 Physical device errors were detected
0x54 Controller has LD cache pinned
0x55 Requested operation is already in progress
0x56 Another power state set operation is in progress
0x57 Power state of device is not correct
0x58 No PD is available for patrol read
0x59 Controller reset is required
0x5a No EKM boot agent detected
0x5b No space on the snapshot repository VD
0x5c For consistency SET PiTs, some PiT creations might fail and some succeed
0xFF Invalid status - used for polling command completion
0x5d Secondary iButton cannot be used and is incompatible with controller
0x5e PFK doesn't match or cannot be applied to the controller
0x5f Maximum allowed unconfigured (configurable) PDs exist
0x60 IO metrics are not being collected
0x61 AEC capture needs to be stopped before proceeding
0x62 Unsupported level of protection information
0x63 PDs in LD have incompatible EEDP types
0x64 Request cannot be completed because protection information is not enabled
0x65 PDs in LD have different block sizes
0x66 LD Cached data is present on a (this) SSCD
0x67 Config sequence number mismatch
0x68 Flash image is not supported
0x69 Controller cannot be online-reset
0x6a Controller booted to safe mode, command is not supported in this mode
0x6b SSC memory is unavailable to complete the operation
0x6c Peer node is incompatible
0x6d Dedicated hot spare assignment is limited to array(s) with same LDs.
Number Event Text
To Next Page
Loading...
