LSI Corporation
- 377 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Appendix B: 3ware CLI Commands to StorCLI Command Conversion
B.3 Alarm Commands
Table 60 Alarm Commands
B.4 Patrol Read and Consistency Check Commands
Table 61 Patrol Read and Consistency Check Commands
NOTE The 3ware CLI combines both patrol read and consistency check into
a single command. The StorCLI has different commands for each.
Description 3Ware CLI Command StorCLI Command
Set alarm properties. /cx/ex/almx set
alarm=<mute|unmute|off>
NOTE The 3ware® controllers have enclosure alarms.
/cx set alarm=<on|off|silence>
NOTE The StorCLI controllers have controller alarms.
Show alarm properties. /cx/ex show alarms
NOTE This command applies for only 9750 and
9690SA controllers.
/cx show alarm
Description 3ware CLI Command StorCLI Command
Show patrol read status and
patrol read parameters, if any in
progress.
/cx/ux show /cx show patrolRead
Set the patrol read options on a
single adapter, multiple
adapters, or all adapters (x =
single controller).
/cx/ux start verify
/cx/ux set autoverify=<on|off>
/cx add verify=dddh:hh:duration
/cx set patrolread {=on
mode=<auto|manual>}|{off}
/cx set patrolread
[starttime=<yyyy/mm/dd hh [maxconcurrentp
d=<value>] [includessds=<on|off>]
[uncfgareas=on|off]
/cx set patrolread delay=<value>
Show consistency check status,
if any in progress, and
consistency check parameters.
/cx/ux show /cx/vx show cc
/cx show ccrate
Set consistency check options
on a single adapter, multiple
adapters, or all adapters
(x = single controller).
/cx/ux start verify
/cx/ux set autoverify=<on|off>
/cx add verify=ddd:hh:duration
storcli /cx set
consistencycheck|cc=[off|seq|conc]
[delay=value] [starttime=yyyy/mm/dd hh] [
excludevd=x-y,z]
To Next Page
Loading...
