EasyManua.ls Logo

Lenze 8400 - Page 102

Lenze 8400
1590 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 Device control (DCTRL)
4.1 Device commands (C00002/x)
102
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Short overview of device commands
Device commands described in this chapter:
Device commands described in other chapters:
C00002
Subcode:
Device command Controller
inhibit
required
Status information
1 Load Lenze setting
dynamic
6 Load all parameter sets
dynamic
11 Save all parameter sets
dynamic
16 Enable/inhibit inverter
static
17 Activate/deactivate quick stop
static
19 Reset error
static
21 Delete logbook
static
27 Device search function
(from version 06.00.00)
static
C00002
Subcode:
Device command Controller
inhibit
required
Status information
23 Identify motor parameters
Automatic motor data identification
dynamic
26 CAN reset node
Reinitialising the CANopen interface
static
28 Check MasterPin
(from version 06.00.00)
Unlocking the inverter with a MasterPin
static
29 Set binding ID
(from version 06.00.00)
Device personalisation
static
30 Delete binding ID
(from version 06.00.00)
Device personalisation
static
31 Set password
(from version 06.00.00)
Password protection
static
32 Check password
(from version 06.00.00)
Password protection
static
33 Delete password
(from version 06.00.00)
Password protection
static

Table of Contents

Other manuals for Lenze 8400

Related product manuals