Lenze 8400 - Page 855

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 855
15 Parameter reference
15.2 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00176
C00177
C00178
C00179
Parameter | Name:
C00176 | Undervoltage threshold for mains OFF
Data type: UNSIGNED_16
Index: 24399
d
= 5F4F
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00177 | Switching cycles
Data type: UNSIGNED_32
Index: 24398
d
= 5F4E
h
Counter of different switching cycles and stressful situations
Display range (min. value | unit | max. value)
0 2147483647
Subcodes Info
C00177/1 Number of mains switching cycles
C00177/2 Number of switching cycles of the output relay
C00177/3 Short circuit counter
C00177/4 Earth fault counter
C00177/5 "Clamp" counter
C00177/6 Counter for "safe torque off" (STO) after power-on
• From version 12.00.00
C00177/7 Counter for controller inhibit via terminal after power-on
• From version 12.00.00
C00177/8 Counter for pulse inhibit (IMP) after power-on
• From version 12.00.00
C00177/9 Service code
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00178 | Elapsed-hour meter
Data type: UNSIGNED_32
Index: 24397
d
= 5F4D
h
Display of operating hours in seconds
Display range (min. value | unit | max. value)
0 s 2147483647
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00179 | Power-on time meter
Data type: UNSIGNED_32
Index: 24396
d
= 5F4C
h
Display of the power-on time in seconds
Display range (min. value | unit | max. value)
0 s 2147483647
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1