Lenze 8400 - Page 903

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 903
15 Parameter reference
15.2 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00464
C00465
C00466
C00467
C00468
Parameter | Name:
C00464 | Remote: Monitoring timeout
Data type: UNSIGNED_16
Index: 24111
d
= 5E2F
h
From version 06.00.00
PC manual control
Setting range (min. value | unit | max. value)
200 ms 5000
Subcodes Lenze setting Info
C00464/1 2000 ms Remote: Monitoring timeout
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00465 | Keypad: Timeout welcome screen
Data type: INTEGER_32
Index: 24110
d
= 5E2E
h
Time setting for the automatic change of the keypad display to the welcome screen
Selection list (Lenze setting printed in bold)
0 Never show welcome screen
55 min
15 15 min
30 30 min
60 60 min
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00466 | Keypad: Default parameter
Data type: INTEGER_32
Index: 24109
d
= 5E2D
h
Setting of the default parameter for the keypad
Setting range (min. value | unit | max. value) Lenze setting
0 65535 51
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00467 | Keypad: Default welcome screen
Data type: INTEGER_32
Index: 24108
d
= 5E2C
h
Selection of the welcome screen for the keypad
Selection list (Lenze setting printed in bold)
0 Main menu
1 Parameter list
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00468 | Service code
Data type: INTEGER_32
Index: 24107
d
= 5E2B
h
This code is for device-internal use only and must not be written to by the user!