Name: Lexmark MX610
Brand: Lexmark
Rating: 5 (1 reviews)

Default Chapter1

Service Manual1

Product Information2

Edition Notice2

Notices and Safety Information15

Preface23

General Information27

Diagnostic Information37

Troubleshooting Overview37
- Performing the Initial Troubleshooting Check37
- Power-On Reset (POR) Sequence38
- Using Safe Mode38
Fixing Print Quality Issues39
- Initial Print Quality Check39
- Gray Background or Toner Fog Check40
- Repeating Defects Check41
- Blank Pages Check41
- Solid Black Pages Check42
- Shadow Images Check42
- Skewed Print Check43
- Streaked Horizontal or Vertical Lines Check45
- Toner Smear Check46
- Toner Specks Check47
Paper Jams47
- Avoiding Jams48
- Understanding Jam Messages and Locations49
- Paper Jams50
- 202 Paper Jams59
- 23Y Paper Jams62
- 241 Paper Jams64
- 242-244 Paper Jams68
- 25Y Paper Jams75
- Mpf Service Check76
- 28Y Paper Jams77
- Adf Paper Jam Service Check78
- 29Y Paper Jams80
- 45Y Paper Jams81
Understanding the Printer Messages97
- Cartridge, Imaging Unit Mismatch [41.Xy]97
- Cartridge Low [88.Xy]97
- Cartridge Nearly Low [88.Xy]97
- Cartridge very Low, [X] Estimated Pages Remain [88.Xy]97
- Change [Paper Source] to [Custom Type Name] Load [Orientation]98
- Change [Paper Source] to [Custom String] Load [Orientation]98
- Change [Paper Source] to [Paper Size] Load [Orientation]98
- Change [Paper Source] to [Paper Type] [Paper Size] Load [Orientation]98
- Check Tray [X] Connection98
- Close Front Door99
- Close Flatbed Cover and Load Originals if Restarting Job [2Yy.XX]99
- Complex Page, some Data May Not Have Printed [39]99
- Configuration Change, some Held Jobs Were Not Restored [57]99
- Defective Flash Detected [51]100
- Disk Full [62]100
- Disk Must be Formatted for Use in this Device100
- Disk Near Full. Securely Clearing Disk Space100
- Error Reading USB Drive. Remove USB100
- Error Reading USB Hub. Remove Hub100
- Fax Memory Full100
- Fax Partition Inoperative. Contact System Administrator100
- Fax Server 'To Format' Not Set Up. Contact System Administrator101
- Fax Station Name Not Set Up. Contact System Administrator101
- Fax Station Number Not Set Up. Contact System Administrator101
- Imaging Unit Low [84.Xy]101
- Imaging Unit Nearly Low [84.Xy]101
- Imaging Unit very Low, [X] Estimated Pages Remain [84.Xy]101
- Incompatible Tray [X] [59]101
- Incorrect Paper Size, Open [Paper Source] [34]102
- Insufficient Memory to Collate Job [37]102
- Insufficient Memory for Flash Memory Defragment Operation [37]102
- Insufficient Memory, some Held Jobs Were Deleted [37]102
- Insufficient Memory, some Held Jobs will Not be Restored [37]102
Insufficient Memory to Support Resource Save Feature [35]102
Load [Paper Source] with [Custom Type Name] [Paper Orientation]103
Load [Paper Source] with [Custom String] [Paper Orientation]103
Load [Paper Source] with [Paper Size] [Paper Orientation]103
Load [Paper Source] with [Paper Type] [Paper Size] [Paper Orientation]103
Load Manual Feeder with [Custom Type Name] [Paper Orientation]104
Load Manual Feeder with [Custom String] [Paper Orientation]104
Load Manual Feeder with [Paper Size] [Paper Orientation]104
Load Manual Feeder with [Paper Type] [Paper Size] [Paper Orientation]104
Maintenance Kit Low [80.Xy]104
Maintenance Kit Nearly Low [80.Xy]105
Maintenance Kit very Low, [X] Estimated Pages Remain [80.Xy]105
Memory Full [38]105
Memory Full, Cannot Print Faxes105
Memory Full, Cannot Send Faxes105
Network [X] Software Error [54]105
No Analog Phone Line Connected to Modem, Fax Is Disabled105
Non-Lexmark [Supply Type], See User's Guide [33.Xy]106
Not Enough Free Space in Flash Memory for Resources [52]106
Paper Changes Needed106
Parallel Port [X] Disabled [56]106
Printer Had to Restart. Last Job May be Incomplete107
Remove Defective Disk [61]107
Remove Paper from Standard Output bin107
Replace Defective Imaging Unit [31.Xy]107
Replace Cartridge, 0 Estimated Pages Remain [88.Xy]107
Replace Imaging Unit, 0 Estimated Pages Remain [84.Xy]107
Replace Maintenance Kit, 0 Estimated Pages Remain [80.Xy]107
Replace All Originals if Restarting Job107
Reinstall Missing or Unresponsive Cartridge [31.Xy]108
Reinstall Missing or Unresponsive Imaging Unit [31.Xy]108
Replace Unsupported Cartridge [32.Xy]108
Replace Unsupported Imaging Unit [32.Xy]108
Restore Held Jobs108
Scanner Automatic Feeder Cover Open108
Scanner Disabled by Admin [840.01]109
Scanner Disabled. Contact System Administrator if Problem Persists. [840.02]109
Scanner Jam, Remove All Originals from the Scanner [2Yy.XX]109
Scanner Jam, Remove Jammed Originals from the Scanner [2Yy.XX]109
Serial Port [X] Disabled [56]109
SMTP Server Not Set Up. Contact System Administrator109
Some Held Jobs Were Not Restored109
Standard Network Software Error [54]109
Standard USB Port Disabled [56]110
Supply Needed to Complete Job110
- Too Many Flash Options Installed [58]110
- Too Many Trays Attached [58]110
- Unformatted Flash Detected [53]110
- Unsupported Disk110
- Unsupported Option in Slot [X] [55]111
- USB Port [X] Disabled [56]111
- Weblink Server Not Set Up. Contact System Administrator111
- User Attendance Messages111
- Printer Hardware Errors117
- Adf/Scanner Hardware Errors150
- Input/Output Option Hardware Errors170

Service Menus175

Repair Information217

Component Locations397

Maintenance409

Parts Catalog414

Appendix A: Printer Specifications449

Appendix B: Options and Features453

Appendix C: Theory of Operation455

Appendix D: Acronyms469

Acronyms469

Index471

Part Number Index481

Part Name Index487

Brand	Lexmark
Model	MX610
Category	All in One Printer
Language	English

Lexmark MX610 Service Manual

Table of Contents

Other manuals for Lexmark MX610

Questions and Answers:

Lexmark MX610 Specifications

Related product manuals