Lexmark MX610 - Toner Starvation Service Check

Action Yes No
Step 6
Replace the UICC. See “UICC removal” on page 277.
Does the error remain?
Go to step 7. The problem is solved.
Step 7
Replace the controller board. See “Controller board removal” on
page 257.
Does the error remain?
Contact the next level
of support.
The problem is solved.
Toner starvation service check
Action Yes No
Step 1
Check the cartridge plunger.
Is the cartridge plunger properly attached to the front door and is the
spring functioning properly?
Go to step 4. Go to step 2.
Step 2
a Install a new cartridge plunger and spring. See “Cartridge plunger
removal” on page 268.
b Print some pages.
Did this fix the problem?
The problem is solved. Go to step 3.
Step 3
Did a 201.22 error display?
Go to step 4. Go to step 5.
Step 4
Try a different toner cartridge.
Did this fix the problem?
The problem is solved. Go to step 5.
Step 5
Check the connections between the cartridge gearbox and the controller
board.
Is the cable properly connected to the cartridge gearbox and to the
controller board?
Go to step 7. Go to step 6.
Step 6
Reconnect the cable to the cartridge gearbox and to the controller board.
Did this fix the problem?
The problem is solved. Go to step 7.
7016
Diagnostic information
144