Flash full service check
Action Yes No
Step 1
Format the flash memory. Navigate to Settings > Print
Settings > Utilities, then select Format Flash.
Does the error remain?
Go to step 2. The problem is solved.
Step 2
Remove the installed memory, and then POR the machine.
Does the error remain?
Go to step 3. Replace the memory
card.
Step 3
Replace the controller board. See “Controller board removal” on
page 257.
Does the error remain?
Contact the next level
of support.
The problem is solved.
Maintenance kit service check
Action Yes No
Replace the maintenance kit and reset the Maintenance counter.
Does the error remain?
Contact the next level
of support.
The problem is solved.
Insufficient memory service check
Action Yes No
Step 1
Disable the Resource save feature:
Settings > Print Settings > Setup Menu > Resource Save > Off
Does the problem remain?
Go to step 2. The problem is solved.
Step 2
Check the memory card for proper installation.
Is it properly installed?
Go to step 3. Reseat the memory
card.
7016
Diagnostic information
115
To Next Page
Loading...
