Lexmark MX610 - ADF Service Check

Actions Yes No
Step 7
Replace the ADF unit. See “ADF unit removal” on page 333.
POR the machine into Configuration menu > Disable scanner. From there,
select Enabled to change the settings to re‑enable the scanner module
and then save the setting.
POR the MPF to operating mode. Try running a copy from the ADF and
flatbed.
Did the 840.xx error reoccur?
Go to step 8. The problem is solved.
Step 8
Inspect JFBM1, JHS1 and J30 on the controller board.
Are they properly connected?
Go to step 10. Go to step 9.
Step 9
Properly connect all the connections.
Did the 840.xx error reoccur?
Go to step 10. The problem is solved.
Step 10
Replace the flatbed unit. See “Flatbed assembly removal” on page 343.
POR the machine into Configuration menu > Disable scanner. From there,
select Enabled to change the settings to re‑enable the scanner module
and then save the setting.
POR the MPF to operating mode. Try running a copy from the ADF and
flatbed.
Did the 840.xx error reoccur?
Go to step 11. The problem is solved.
Step 11
Replace the controller board. See “Controller board removal” on
page 257.
The problem is solved. Contact second‑level
support.
ADF service check
Action Yes No
Step 1
Check all cables connecting the ADF and flatbed to the controller board.
Are they properly connected?
Go to step 3. Go to step 2.
Step 2
Reconnect the cables to the controller board.
Did this fix the problem?
The problem is solved. Go to step 3.
7016
Diagnostic information
152