8 Remove the two screws (B).
9 Disconnect the cable from the sensor.
Trailing edge sensor removal
1 Remove the left cover. See “Left cover removal” on page 239.
2 Remove the right cover. See “Right cover removal” on page 252.
3 Remove the rear door and cover. See “Rear exit door removal” on page 317 and “Rear cover removal” on page
318.
4 Remove the power supply. See “Power supply removal” on page 298.
5 Remove the power supply shield. See “Power supply shield removal” on page 298.
6 Remove the duplex. See “Duplex removal” on page 299.
7 Position the printer so that it sits on its left side.
8 Disconnect the cable JACM1 from the controller board.
9 Release the retainer spring (A) from the bracket (B).
7016
Repair information
306
To Next Page
Loading...
