August 20, 2013
• Fax card (40X7854) was included in the parts catalog.
August 13, 2013
• Topic for restoring the printer configuration after replacing the controller board was added.
• Additional procedure added for the installation note for the controller board removal topic.
• Parts catalog FRU (40X9099—Top cover) was included.
July 11, 2013
• Parts catalog FRU (40X8700—Relocation kit) was added.
June 25, 2013
• Parts catalog FRU number (40X9134—Controller board) was changed to 40X8857.
June 19, 2013
• Changes were made to the ADF paper jam service check.
• Installation warning was added to the Bin full sensor removal.
• Part number 40X8093 (Transfer roll) was changed to 40X8393.
• BSD model information was added to the FRU tables on the parts catalog.
• Some information from the error code tables were made into new service checks. The following are the new service
check topics added:
– ADF rattling noise service check
– Imaging unit low service check
– Toner cartridge low service check
– Bin full service check
– Toner smart chip compatibility service check
– Imaging chip compatibility service check
– Flash full service check
– Maintenance kit service check
– NVRAM cyclic redundancy service check
– Invalid firmware/controller board service check
– RAM memory error service check
– Scanner configuration error service check
– Blank spaces on incoming fax service check
– Stretched words on incoming fax service check
– Download emulation cyclic redundancy service check
March 27, 2013
• Updated the ACM assembly removal procedure.
• Added Media sensor flag removal procedure.
• Updated the Sensor (input) early/late arriving service check to include checking of the media present sensor flag.
• Added media present sensor flag part number 40X8800 to the Electronics 2 parts catalog assembly.
7016
Preface
24
To Next Page
