Lexmark MX610 - Page 478

stapler left cover 356
stapler left tamper motor 368
stapler paddle motor 364
stapler power supply unit 372
stapler rear cover 364
stapler rear cover close limit switch 370
stapler rear door 357
stapler right cover 355
stapler right tamper motor 369
stapler service cover 368
stapler top cover 376
tamper drive belt 389
tamper main assembly 386
tamper sub-assembly 387
toner cartridge smart chip contact 261
toner density sensor 305
top cover 324
trailing edge sensor 306
transfer roll 267
trapped staple access door 367
tray guide 314
tray present sensor 255
UICC 277
USB cable 340
USB cable bracket 279
USB wireless cable 341
remove all pages from the output bin. Leave paper in
bin. [45y.xx] 81
Remove defective disk [61] 107
Remove paper from standard output bin 107
Replace all originals if restarting job. 107
Replace cartridge, 0 estimated pages remain
[88.xy] 107
Replace defective imaging unit [31.xy] 107
Replace imaging unit, 0 estimated pages remain
[84.xy] 107
Replace maintenance kit, 0 estimated pages remain
[80.xy] 107
Replace unsupported cartridge [32.xy] 108
Replace unsupported imaging unit [32.xy] 108
reports
event log 202
menu settings page 202
Restore held jobs? 108
S
safe mode 38
safety information 18
Scanner automatic feeder cover open 108
Scanner calibration
menu settings page 181
scanner calibration reset 200
Scanner configuration 204
Scanner disabled by admin [840.01] 109
Scanner disabled. Contact system administrator if
problem persists. [840.02] 109
scanner glass
cleaning 412
Scanner jam, remove all originals from the scanner
[2yy.xx] 109
Scanner jam, remove jammed originals from the
scanner [2yy.xx] 109
scanner manual registration 205
scanner specifications 450
scanner tests
ADF magnification 200
ASIC 196
feed test 197
motor tests 196
scanner calibration reset 200
sensor tests 197
scheduled maintenance 410
security slot 398
selecting paper 29
sensor tests 197
Serial port [x] disabled [56] 109
serial wrap test 184
service checks troubleshooting
8yy service error messages 150
network service check 147
service engineer (SE) menu 214
accessing 214
service manual conventions 23
shadow images appear on prints 42
SMTP server not set up. Contact system
administrator. 109
solid black pages 42
Some held jobs were not restored 109
Specifications
electrical 449
specifications
acoustics 450
environment 450
fax 451
operating clearances 449
scanner 450
Standard network software error 54] 109
Standard USB port disabled [56] 110
storing
paper 29
Supply needed to complete job 110
supported paper sizes 32
symptoms
printer 140
7016
Index
478