5 Close the finisher rear door.
6 If necessary, touch Done from the printer control panel to clear the message and continue printing.
45y paper jam messages
Error code Description Action
451.01 Media remains detected by the sensor (stapler pass
through) after power on.
Go to “Finisher jam service check” on page 92.
451.03 The media fed did not reach the sensor (stapler pass
through).
Go to “Finisher jam service check” on page 92.
451.05 While feeding, the media remains detected by the
sensor (stapler pass through).
Go to “Finisher jam service check” on page 92.
451.09 Page In Output is never received from the staple
finisher.
Go to “Finisher jam service check” on page 92.
451.10 Invalid Page ID returned by the staple finisher. Go to “Finisher jam service check” on page 92.
451.41 Staple finisher main motor stalled. Go to “Finisher jam service check” on page 92.
451.42 Staple finisher main motor did not reach the required
speed.
Go to “Finisher jam service check” on page 92.
451.43 Staple finisher took too long to ramp up the stapler
main motor.
Go to “Finisher jam service check” on page 92.
452.73 Staple finisher left tamper failed to leave its home
position.
Go to “Stapler left tamper jam service check” on
page 94.
452.74 Staple finisher left tamper failed to reach its home
position.
Go to “Stapler left tamper jam service check” on
page 94.
453.75 Staple finisher right tamper failed to leave its home
position.
Go to “Stapler left tamper jam service check” on
page 94.
453.76 Staple finisher right tamper failed to reach its home
position.
Go to “Stapler left tamper jam service check” on
page 94.
454.41 Staple finisher ejector motor stalled. Go to “Ejector jam service check” on page 91.
7016
Diagnostic information
89
To Next Page
Loading...
