Tray 1 feed jam service check
Action Yes No
Step 1
Enter the Diagnostics menu, and then navigate to:
EVENT LOG > Display Log
Do most of the recent error codes end with a 1? (Example: 241.11, 200.91)
Go to step 2. Go to step 7.
Step 2
Make sure that the tray 1 feed paper path, including the sensors, are free
of debris or dust.
Does the problem remain?
Go to step 3. The problem is solved.
Step 3
Check the sensor (tray 1 paper feed).
Is it free of damage?
Go to step 4. Go to step 6.
Step 4
Enter the Diagnostics menu, and then navigate to:
SENSOR TESTS > PRINTER SENSOR TESTS > Tray 1 paper feed
Does the sensor status change while toggling the sensor?
Go to step 7. Go to step 5.
Step 5
a Reseat the tray 1 paper feed sensor cable.
b Check the cable for damage, and replace if necessary.
Does the problem remain?
Go to step 6. The problem is solved.
Step 6
Replace the sensor (tray 1 paper feed).
Does the problem remain?
Go to step 7. The problem is solved.
Step 7
Enter the Diagnostics menu, and then navigate to:
INPUT TRAY TESTS > Feed Tests > Tray 1
Does the leading edge of the paper reach the sensor (tray 1 paper feed)?
Go to step 14. Go to step 8.
Step 8
Check the tray 1 feed, pick, and separator rollers for damage, and replace
if necessary.
Note: If the page count is over 50K, then clean the rollers.
Does the problem remain?
Go to step 9. The problem is solved.
7421
Diagnostic information
84
To Next Page
Loading...
