Malfunctions in driving mode
8.5 Emergency operation and breakdown assistance
Operating manual 3 302 736 en 8 - 41
GMK4090
xx.xx.xxxx
Check valves – switch off continuous opera-
tion
• Always switch off the continuous operation
for all valves (1).
• (A) – Remove the nut (2) from the valve (4).
• (B) – Fit the magnets (3) – pay attention
marking!
• Tighten the nut (2) hand-tight on the
valve (4).
Inserting the fuses
After emergency operation, you must insert the fuses again so that the 4th
axle line can be steered while driving.
• Turn off the ignition.
• Insert the fuse F2/5; à Fuses in the driver's cab, p. 8 - 50.
• Insert the fuse F10; à Fuses in the battery box, p. 8 - 56.
After emergency
operation
• Drive directly to the workshop and have the fault rectified.
The speed may be reduced depending on the extent of the error.
To Next Page
Loading...
Need help?
General
