Charging and Starting System
Page 2B-22 90-8M0050731 MAY 2011
5. Remove the screw securing the pulley to the belt tensioner.
a - Bushing
b - Screw securing the pulley
c - Grease fitting
Installation
1. Install the pulley to the belt tensioner and secure with a M10 x 35 screw. Tighten the screw to the specified torque.
2. Lubricate the belt tensioner bushing with 2‑4‑C with Teflon. Install the bushing into the belt tensioner.
3. Replace the grease fitting if damaged or corroded.
a - Bushing
b - Screw securing the pulley
c - Grease fitting
Description Nm lb‑in. lb‑ft
Screw (M10 x 35) 34 25
Tube Ref No. Description Where Used Part No.
95
2-4-C with Teflon Belt tensioner 92-802859A 1
4. Lubricate the washer with 2‑4‑C with Teflon and install onto the belt tensioner stud.
NOTE: Lubricate the belt tensioner spring contact surfaces on the tensioner arm with 2‑4‑C with Teflon. The grease fitting on
the tensioner assembly does not apply lubricant to this area.
5. Install the belt tensioner spring. Verify the end of the spring is in the aft facing slot on the cylinder block.
a -
Washer
b - End of the spring facing aft
To Next Page
Loading...
Need help?
General
