Jet Installation
Page 1D-38 90-8M0050731 MAY 2011
Predelivery Inspection
Not Applicable
Check/
Adjust
CHECK BEFORE RUNNING Not Applicable
Check/
Adjust
ON THE WATER TEST
  Water hose connection torqued  
Idle________ RPM, within
specifications
 
Cover plate and adapter plate
fasteners torqued
 
Forward ‑ Neutral ‑ Reverse
operational
  Battery meets engine specification  
Steering operation throughout
range
  Battery charged and secure   Acceleration test
  All electrical connections tight   WOT________ RPM
  All fuel connections tight   Ignition timing set to specs
 
Throttle, shift, and steering system
adjusted correctly and fasteners
torqued
  Boat handling
 
Shift cable adjusted to keep the
reverse gate above the rudder in
forward with slack pulled out of cable
and against stop
 
AFTER ON WATER TEST
  Pump housing oil level full   Torque adapter plate fasteners
  Oil injection reservoir full and bled  
No fuel, oil, water, or exhaust
leaks
  Warning system operational  
Check shift cable adjustment.
Readjust as necessary.
ON WATER TEST
 
Starter neutral safety switch
operational
  Lanyard stop switch operational
  All gauges read properly
  No fuel leaks
  No oil leaks
  No water leaks
  No exhaust leaks
To Next Page
Loading...
Need help?
General
