140 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Chapter 4
Navigation Windows
The authentication file is provided with the upgrade file and verifies that this
SyncServer unit is authorized to upgrade with the specified upgrade file.
Note: You can check for the latest version number of SyncServer
S600 and S650 software at these URLs:
http://update.microsemi.com/SyncServer_S600
http://update.microsemi.com/SyncServer_S650
The number of the most current version of the software will appear.
You can compare this to the version number installed in the
SyncServer by proceeding to the web GUI Dashboard and finding the
version number in the About drop down on the right side. If you do not
have the latest version installed consider contacting Technical
Support.
Note: For releases after 1.1, if the upgrade process is used to load a
previous (older) version of the software, then the unit will reset the
configuration to factory default values.
Note: If the all-packets limit on LAN1 has been reduced on the
Security->Packet Monitoring page, then it is recommended that the
limit be temporarily increased back to the default value of 13000
packets/second. Otherwise, the file upload will be very slow and may
timeout.
To Next Page
Loading...
