Microsemi SyncServer S600 - Page 264

264 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Appendix A System Messages
System Notification Messages
NTP Leap Indicator
Changed
163 Notify No NTP Leap Indicator
Changed
n/a
No action required.
n/a
System Upgrade
Available
164 Notify No System upgrade available
n/a
Upgrade unit software.
n/a
J1A IRIG Input
Protocol Fault
170 Minor No J1A IRIG Input protocol
fault
J1A IRIG Input protocol
fault cleared
Verify IRIG configuration
matches source
configuration.
No action required
J1B IRIG Input
Protocol Fault
171 Minor No J1B IRIG Input protocol
fault
J1B IRIG Input protocol
fault cleared
Verify IRIG configuration
matches source
configuration.
No action required
Holdover Exceeded 172 Minor No Holdover time error
threshold exceeded
Holdover time error
threshold cleared
Same as for entering
holdover
No action required
Leap event pending 173 Notify No Leap event pending
Leap event pending
cleared
No action required
Table A-1. System Notification Messages (Continued)
Description
Event
ID
Msg
Level
Trans-
itory
MsgText Corrective Action