CHAPTER 4
APPLICATION FUNCTIONS
This chapter describes helpful functions that facilitate operation.
Table of Contents
ASSIGNMENT OF PEN NUMBERS [MODE SET] > [PEN ASIGN]
............................................................4-2
RE-CUT OF THE SAME DATA [COPY]
..................................................................................................................4-4
SETTING THE NUMBER CUT FUNCTION [MODE SET] > [MULTI-PASS]
.........................................4-6
SETTING THE ONE-STROKE CUTTING [MODE SET] > [ONE STROKE]
............................................4-8
SETTING THE DIRECTION OF ROTATION FOR THE COORDINATE AXIS [MODE SET] >
[ROTATE]
.............................................................................................................................................................................4-9
SETTING THE CUTTER STROKE [MODE SET] > [Z STROKE]
..............................................................4-10
SETTING THE UNIT TO BE USED FOR INDICATION [MODE SET] > [UNIT]
............................... 4-11
SETTING THE DUMMY CUT OPERATION OF THE SWIVEL BLADE [MODE SET] > [DUMMY
CUT]
.................................................................................................................................................................................... 4-12
ALIGNMENT OF MECHANICAL AXES TO RULED LINES PRINTED [AXIS ALIGN]
.................... 4-13
EXPAND THE CUTTING AREA [EXPANDS]
.................................................................................................... 4-15
To Next Page
Loading...
