MIMAKI CF2 Series User Manual

4-9
SETTING THE DIRECTION OF ROTATION FOR THE COORDINATE AXIS [MODE SET] > [ROTATE]
In the case where the command origin is established at the lower left of the cutting area, it is necessary to specify the
direction of rotation for the coordinate axis in accordance with your CAD.
Set values
+90°: Lower right of the maximum effective cutting area
–90°: Upper left of the maximum effective cutting area
1. Press the key several times until the LCD indicates
page 3 of the LOCAL MENU.
2. Select the [MODE SET].
3. Press the key several times until the LCD indicates
page 3 of the [MODE SET].
4. Select one of the following as a setting for the
[ROTATE].
+90°, -90°
5. Enter the input values.
Press the key to enter the input values. If you do not enter the
input data, press the key.
Maximumeffective
cuttingarea
Maximumeffective
cuttingarea
Maximumeffective
cuttingarea
Y-axis
Y-axis
Y-axis
X-axis
X-axis
X-axis
In the case where the
command origin is set to
the lower left corner
In the case where the
direction of rotation is
set to 90°
In the case where the
direction of rotation is
set to -90°
［LOCAL］ １ ／ ４
TOOL SELECT ――― ＞
CONDITION ――― ＞
TEST CUT ――― ＞
［LOCAL］ ３ ／ ４
INTERFACE ――― ＞
MODE SET ――― ＞
SELF TEST ――― ＞
< MODE SET > １ ／ ６
Z STROKE ＊ ７ ｍｍ ＞
MULTI–PASS ――― ＞
RESERVE
< MODE SET > ３ ／ ６
ROTATE ― ９ ０ ° ＞
COMMAND ――― ＞
CMD Ｓ Ｗ ∗ INVALID ＞
< MODE SET > ３ ／ ６
ROTATE ― ９ ０ ° ＞
COMMAND ――― ＞
CMD Ｓ Ｗ ∗ INVALID ＞

MIMAKI CF2 Series Specifications

General

Brand	MIMAKI
Model	CF2 Series
Category	Plotter
Language	English