MIMAKI CF2 Series User Manual

SETTING OF REGISTER MARK DETECT OPERATION
5-11
Settings for detection of marks
Make the settings of the following fuve functions to detect register mark.
Detect Register Mark :
The higher the number of detected points, the higher the cutting accuracy. Select “1pt” when using
FuneCut.
Size :
Shape :
Setting Description
OFF Select this setting for cutting a normal sheet, not for cutting the outline.
If set the Expand mode to valid, this setting is automatically set to OFF.
1pt Detects the TP1. Sets only the origin.
2pt Detects the two register marks TP1 and TP2. Performs the skew compensation
and the scale compensation in the Y direction.
3pt Detects the three register marks TP1,TP2, and TP3. Performs the skew compen-
sation and the Y scale compensation in the work X direction and Y direction.
4pt Detects the four register marks TP1,TP2, TP3, and TP4. Performs the skew com-
pensation, and the scale compensation in four points.
Setting Description
5 to 30mm Set the side length of register mark.
Description Description
Square
Single
Double
Select the register mark shape from below 3 types.
Square Single Double

MIMAKI CF2 Series Specifications

General

Brand	MIMAKI
Model	CF2 Series
Category	Plotter
Language	English