2-21
ATTACHING THE WORK HOLDER
The work holder prevents the work from moving up after it is cut.
1. Remove the fixing screw of unit B.
To loosen the screw, turn it counterclockwise.
2. Set the work holder to unit B and tighten the screw.
• The work holder can be used for works of up to 10 mm thick.
The work holder does not support thickness greater than 10 mm.
• When using soft works (sponges, etc.), do not use the work holder. The work holder is
designed to hold works such as corrugated fiberboard.
• When using a work holder, be sure that overall bottom surface
is flat against the work.
If bottom surface run off the work edge, in a case cutting edge
of a work, cutter does not down and may not cut correctly.
Set the work holder
by aligning its hole
with the screw hole
on unit B.
To Next Page
Loading...
Need help?
General
