MIMAKI CF2 Series - Re-Cut of the same Data [Copy]

4-4
RE-CUT OF THE SAME DATA [COPY]
Data that has been already cut can be re-cut in the off-line state. This means that the same data need not be transmit-
ted from the computer in repetition.
1. Execute the [DATA CLEAR].( P. 2-40)
Execute the data clear function immediately before receiving the object data to be copied.
2. Cut a pattern according to the object data.
3. Cause the device to enter the LOCAL mode.
4. Shift the origin using the jog keys.( P. 2-39)
Re-set the origin to a position at which the object data is to be cop-
ied. If the origin is re-positioned, the device will perform cutting at
the position same as the previous cutting.
5. Invoke the 2nd page of the LOCAL menu on the screen.
6. Select the [COPY].
• Be sure to execute the “DATA CLEAR” to clear data from the receiving buffer before trans-
mitting data to be copied. If the “DATA CLEAR” is not executed, pieces of data other than
the object data will be copied.
Origin
[LOCAL］ １ ／ ４
TOOL SELECT ――― ＞
CONDITION ――― ＞
TEST CUT ――― ＞
Newly specified origin
[LOCAL］ １ ／ ４
TOOL SELECT ――― ＞
CONDITION ――― ＞
TEST CUT ――― ＞
[LOCAL］ ２ ／ ４
DATA CLEAR ――― ＞
COPY ――― ＞
VIEW ――― ＞